Diagnostic Tool for Opel Op Com Op-com Pic18f458 Firmware Opcom V1.99

The diagnostic interface is USB port based, so there will be no compatibility problems with serial-to-USB converters. 2. The communication speed over the USB-BUS is sufficient to handle the awesome speed of the high-speed CAN-BUS systems, which is currently 500kbps. This is the main reason why only USB port based interfaces are available for CAN-BUS. 3. The program supports many control units, such as engine, automatic transmission, ABS, airbag, engine cooling system module, instrument cluster, electronic climate control, body control unit 4. The program supports many control units, such as engine, automatic transmission, ABS, airbag, engine cooling system module, instrument cluster, electronic climate control, body control unit, just to name a few. Since many pins are used in the OBD connector for Opel, the diagnostic interface works as a multiplexer and selects the appropriate pin for communication. PIN3, PIN7, PIN8, PIN12 = Serial Link (ISO9141, KW81, KW82, KWP2000)5. Fault codes will be shown with all available information: Full status information (Present, Not present, Intermittent)6. The program shows measuring block information on many control modules, you can choose anything from the list on your own.7. You can also run output tests on many controllers.PIN6-PIN14PIN3-PIN11PIN1HSCAN - Two-wire, High Speed CAN-BUS, 500 kbpsMSCAN - Two-wire, Medium Speed CAN-BUS, 95 kbpsSWCAN - Single-wire, Low Speed CAN-BUS, 33.3 kbpsincludes:1 x OP-COM Interface1 x USB Cable1 x CD